Techt Rear Bolt

TechT Zero Kick Hammer Installation Guide Update

The newest version of the TechT Zero Kick Hammer for Tippmann Paintball Guns comes packaged with a new hammer drive spring. If you did not receive this drive spring and you think your marker needs it, please contact TechT. They will send you the drive spring for free. If you did not receive one, there is no need to freak out immediately. You may not need it. TechT found that some users’ markers needed a stiffer spring in order to get up to 300FPS. Most markers didn’t, but some did, so they started to include it with the hammer.

With that said, below are the instructions on how to install the hammer. Again, I would first set it up with your stock hammer drive spring. If you can not achieve high enough velocity or your cyclone is not cycling you will then need to swap out your stock spring for the stiffer one from TechT.

If you need to contact TechT for the stiff hammer drive spring please call – 901-405-1848 ex.11

For complete installtion instructions, visit the TechT Zero Kick installation page at http://www.techtpaintball.com/hammer_install.html

TechT Zero Kick Rear Bolt for Tippmann’s and BT’s

TechT has released a new rear bolt upgrade called the Zero Kick.  It fits all Tippmanns including 98’s, A5’s, and X7’s.  It’s also compatible with the BT4 and BT Delta guns.  This new rear bolt is almost half the weight of the stock rear bolt greatly reducing the amount of kick in your gun.  Because of the lighter weight, the bolt also moves back and forth quicker.  This effectively increases your gun’s potential rate of fire.  It weighs in at only 69.9 grams and is made out of a hardened material that gives it a longer wear life.

You can purchase  the TechT Paintball Zero Kick Tippmann Rear Bolt here on TippmannParts.com.